High-Gloss Sealer

Key Features

May be used as a pre-grouting sealer
Allows moisture vapor transmission
Safe to use, low odour, low VOC
Is unaffected by ultra-violet light
Last up to 3 years

For use on

Unsealed, textured natural stone, textured porcelain tiles, clay pavers including Saltillo, terra-cotta and adobe, cement tile, quarry. Internal use only.

Description

High Gloss Sealer is a specially formulated water-based blend of acrylic polymers that provides both a stain resistant surface seal and a durable high-sheen finish, eliminating conventional two-step methods utilising a sealer and finish. High Gloss Sealer allows moisture vapor transmission and is unaffected by ultra-violet light.

Limitations

Not recommended for use on smooth glazed ceramic or porcelain tile, as surface must be rough-textured to ensure adequate bonding.
Do not allow product to come in contact with any non-recommended surface.
Not recommended for use in or around pools, showers or areas subject to standing water.
Not recommended for use on countertops.
Keep surface clean and dry to reduce possibility of slip-fall accidents.

General Surface Prep

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product. Surface should be dry, clean and free of waxes, sealers, or finishes. Do not apply directly over silicone sealers, oil or wax based finishes. Aqua Mix® Sealer & Coating Remover will strip the surface and remove wax or old acrylic finishes. Place a few drops of water on various tiles. If water doesn’t penetrate, additional removal is necessary. New installations need to be dry at least 48 hours before application. Clay and Saltillo tile may require extended drying time depending on temperature and humidity. Make sure the tiles are completely dry before application. Test product in an inconspicuous area to ensure desirable results.

Application of Product

Read entire label before using. For new installations sealer can be applied as soon as 48 hours after grouting. Surface must be clean, dry and free of existing sealers and coatings. Apply 2-3 coats of sealer with a clean dense sponge, brush or paint pad applicator in thin, even coats. Allow 30 minutes drying time between coats. Avoid puddling. The Stone, Tile or Grout must be dry prior to applying sealer – the following document explains in detail the definition of the term “dry” as it relates to sealer application. READ MORE

Product Data Sheets

Technical Data Sheets

Safety Data Sheets

Problem Solving Guides

Pre-Grouting Application

Apply over clean stone or tile a minimum of 2 hours prior to grouting – follow application procedures above.

Drying Time

Ready for surface traffic 6 hours after final coat.
Keep area dry for at least 12 hours.
Achieves a full cure in 24 hours.

Product Maintenance

General Maintenance Guide for surfaces sealed with a Topical / Coating Sealer

VOC Content

Maximum VOCs: 51 grams per litre

Available in

946ml, 3.8L.

Product Warranty

Custom® Building Products warrants to the original consumer purchaser that its product shall be free from defects in material and workmanship under normal and proper usage for a period of one year following the date of original purchase. CUSTOM’s sole liability under this warranty shall be limited to the replacement of the product. Some states, countries or territories do not allow the exclusion or limitation of incidental or consequential damages, so the above limitation or exclusion may not apply to you. This warranty will not extend to any product which has been modified in any way or which has not been used in accordance with CUSTOM’s printed instructions. CUSTOM makes no other warranties either expressed or implied. This warranty gives you specific legal rights, and you may have other rights that vary from state to state or from one country/territory to another. This warranty is not transferrable.

Require Technical Assistance?

Please contact us at 1300 AQUA MIX or info@aquamix.com.au