A non-acidic honing powder that removes light surface scratches, moderate acid etching and wear patterns to produce a flat, even and honed finish. It is excellent for safely honing polished marble, limestone or travertine to a smooth honed surface when a honed, unpolished finish is desired.

honing powder

  • Easy to use
  • Non-acidic

For use on:

Limestone, marble, travertine.

Limitations:

  • Do not allow product to come in contact with any non-recommended surface.
  • Not intended for use as a pre-polish powder

General Surface Prep

Test a small area according to application instructions to determine desired results.

Equipment

  • 175 to 300 RPM floor machine or 600 to 900 RPM hand polish machine
  • Natural hair or synthetic fiber tan floor pads
  • KnockDown™
  • Protective plastic or blue painter’s tape
  • Spray bottle of water
  • Wet vacuum
  • Mop and bucket Squeegee

Application Method:

USE CHEMICAL-RESISTANT GLOVES, such as nitrile, when handling product. Read entire label before using. Test in a small inconspicuous area to determine desired results. Sweep or vacuum surface. Protect baseboards, carpet, etc. with protective plastic and/or blue painters tape. Surface must be free of existing sealers or coatings. Liberally apply KnockDown® to the stone surface. Add water to form a slurry. Refinish using a weighted floor machine fitted with a natural hair or synthetic fiber tan floor pad or use a hand polishing machine. If lippage is present, use two pads, double stacked. Keep slurry wet while buffing. Add KnockDown® as needed. Harder stones will require a thicker slurry. Buff area until the desired level of hone has been achieved squeegee slurry from a small area to check for desired results prior to removing slurry. Rinse well and use a wet vacuum to remove all excess compound.

Cleaning of equipment

Clean tools with water before material dries

Data Sheets:

Technical Data Sheet

Safety Data Sheet

Problem Solving Guide

VOC Content

No VOCs

pH:

7-9

Available in: 

0.9 Kg

Product Warranty